Removing the Reel Drive Assembly
1. Park the machine on a level surface, turn the key switch to the O
FF
position,
and remove the key from the key switch. Disconnect the battery pack; refer
to
Connecting the Lithium Battery Pack (page 4–3)
.
g203645
Figure 26
1.
Telescoping coupler
2.
Cutting unit hex shaft
2. Slide the telescoping coupler off the cutting unit hex shaft (
).
3. Remove the reel drive belt; refer to
Reel Drive Belt (page 4–14)
.
4. Loosen the 2 set screws (item 11 in
) that the secure the reel
pulley (item 18 in
) to the reel driveshaft. Slide the pulley from the
driveshaft. Locate and retrieve the woodruff key from the shaft.
5. Remove the washer-head screw (item 9 in
) that secures the reel
drive housing to the cutting unit side plate.
Note:
The 2 hex nuts (item 24 in
) have adhesive applied during
cutting unit production. The nuts must remain in cutting unit side plate during
the reel drive housing removal.
6. Remove the 2 flange-head screws (item 20 in
) that secure the reel
drive housing to the cutting unit side plate.
7. Remove the reel drive assembly from the cutting unit.
8. Remove the components from the reel drive housing as necessary (
9. If the idler shaft ball bearings (item 8 in
) are to be removed, use a
press to remove the bearings and the bearing spacer from the shaft. Discard
the bearings after removal.
Note:
Refer to
Reel Drive Bearing Housing (page 4–19)
for disassembly and
assembly information of bearing housing assembly (item 2 in
).
Note:
The reel pulleys (items 12, 18, and 19 in
) can be identified by
color and number of teeth. The location of pulley can vary based on desired
cutting unit clip frequency; refer to
Adjusting the Cutting Unit Clip (page 4–10)
.
Greensmaster
®
eFlex 1800, 2100 and 2120
Page 4–17
Traction and Reel Drive System: Service and Repairs
12189SL Rev E
