Tomey UD-600, Operator'S Manual, Page: 36 / 262

3-8
„ „
„ „
„
The direction of the connector for video printer is speci-
fied. Sufficiently insert the connector in specified direc-
tion, without causing any looseness.
„ „
„ „ „ And be sure to use specified printer and the cable. This
instrument must be connected to the equipment comply-
ing with the IEC60601-1 or with the IEC60950-1 of which
power source shall be isolated with the isolating trans-
former, with the use of the video signal cable and the re-
mote cable.
1) Insert the D-sub 15 pin connector
A
for video signal cable into
the video signal terminal B located at the rear side of the main
unit in specified direction.
2) Secure the fixed screw C by turning.
3) Connect another BNC connector for video signal cable to the
video printer.
<In case of the monochrome printer>
Connect the BNC connector for green color to the signal
terminal for videoprinter. No other connector is required
to be connected, since they are not used.
<In case of the color printer>
Connect the red, green, and blue colored BNC connectors
to the video signal terminals for video printer. No other
cables are required to be connected, since they are not used.
Refer to the Instruction Manual for Video Printer for the
details of the connection of the Printer.
4) Insert the connector
D
for one side of the remote cable
into the video printerremote terminal
E
located at the rear
side of the main unit.
5) Connect another connector of the remote cable to the video
printer, inaccordance with the Instruction Manual of the
Video Printer. As for the details of connecting procedures,
see the Instruction Manual of the Video Printer.
<Video printer monochrome/color selection>
In case of the printer which is connected to the instrument is a
color printer, change over the video printer monochrome/color
select switch
F
provided at the rear side of the main unit to the
side of C, while if connected to the monochrome printer, turn
the switch to the side of M.
3.2 Preparation before operation