Thermal Dynamics ULTRA-CUT 200 XT, Operating Manual

Page: 50 / 228

ULTRA-CUT 200 XT
3-22 INSTALLATION Manual 0-5304
2. Carefully remove the cover from the module noting the attached wire harness that connects to J1. Remove the wire
harness and then set the cover to the side.
Art # A-09140
3. Attach all hoses and cables to the front of the DMC-3000 except the Fiber Optic cable which will be covered a little later.
Avoid turning any fittings already mounted in the unit by placing a wrench on it before tightening the hose fitting to it.
Art # A-09141_AB
NOTE!
Argon must be used for the “Marking” gas. If replacing existing fittings in the base, apply thread seal-
ant to the fitting threads, according to manufacturer’s instructions. Do not use Teflon tape as a thread
sealer, as small particles of the tape may break off and block the small air passages in the torch.
NOTE!
If you need to replace a gas or water fitting all inlets and outlets of the aluminum manifold are 1/4”
NPT (United States National Pipe Thread) into which are screwed the various adapters.
4. Connect the ground cable to rear of DMC-3000 shown in previous illustration.