Thermal Dynamics ULTRA-CUT 200 XT, Operating Manual

Page: 222 / 228

ULTRA-CUT 200 XT
A-96 APPENDIX Manual 0-5304
Check Air Quality
Air must be free of oil and moisture. To test the quality of air:
1. Pull trigger momentarily to initiate gas/air flow.
2. Place a welding filter lens in front of the torch and turn ON the air. Do not start an arc!
Any oil or moisture in the air will be visible on the lens.
Air Pressure Control
The Pressure
+
Control is used to set the air pressure. Pull the torch trigger momentarily to start gas
flow. To adjust the pressure pull the knob out and push in to lock.
1. Ensure source meets requirements.
Inlet Pressure: 90 psi min. - 120 psi max. (6.2 bar min - 8.3 bar max).
Inlet Flow: 6.7 CFM (189 lpm).
2. Check connections and turn air supply ON.
3. For cutting, adjust output air pressure from 70 - 85 psi / 4.8 - 5.9 bar. Refer to the chart for pressure setting
details.
Gas Pressure Settings
Leads
Length
SL100
(Hand Torch)
Up to 25'
(7.6 m)
70 psi
4.8 bar
Each additional
25' (7.6 m)
Add 5 psi
0.4 bar
Installing Optional Single - Stage Air Filter
An optional filter kit is recommended for improved filtering with compressed air, to keep moisture and debris out
of the torch.
1. Attach the Single - Stage Filter Hose to the Inlet Port.
2. Attach the Filter Assembly to the filter hose.
3. Connect the air line to the Filter. The illustration shows typical fittings as an example.
NOTE!
For a secure seal, apply thread sealant to the fitting threads, according to the maker’s instruc-
tions. Do Not use Teflon tape as a thread sealer, as small particles of the tape may break off and
block the small air passages in the torch. Connect as follows: