Thermal Dynamics ULTRA-CUT 200 XT, Operating Manual

Page: 221 / 228

ULTRA-CUT 200 XT
Manual 0-5304 APPENDIX A-95
Connecting Air Supply to Unit
The SL100 torch option needs a separate air supply from that of the XT power supply. The connection is the
same for compressed air or high pressure cylinders. Refer to the following two subsections if an optional air
line filter is to be installed.
1. Connect the air line to the inlet port. The illustration shows typical fittings as an example.
NOTE!
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer’s in-
structions. Do not use Teflon tape as a thread sealer, as small particles of the tape may break off
and block the small air passages in the torch.
Art # A-12759
Hose Clamp
Inlet Port
Gas Supply
Hose
1/4 NPT or ISO-R
to 1/4” (6mm) Fitting
Air Connection to Inlet Port