Taylor TX180S, Maintenance Manual

Page: 117 / 320

TX / TXH / TXB 180S - 400L (Rev. 4/23/07) TX / TXH / TXB 180S - 400L (Rev. 4/23/07) 6-42 6-42
DEPRESS TO TOGGLE DEPRESS TO TOGGLE
BETWEEN RAW AND BETWEEN RAW AND
SCALED VALUES SCALED VALUES
Engine Fault Code Measure Group Engine Fault Code Measure Group
Valve Current Setting Adjustments Valve Current Setting Adjustments
The valves (used to actuate The valves (used to actuate the tilt and hoist functions the tilt and hoist functions ) are controlled by output modules. ) are controlled by output modules. There are four There are four
settings that can be adjusted for each function and the range of values allowed is controlled by the soft- settings that can be adjusted for each function and the range of values allowed is controlled by the soft-
ware. ware. These parameters (minimum current, m These parameters (minimum current, m aximum current, start ramp t aximum current, start ramp t ime and stop ramp time) are ime and stop ramp time) are
set by T set by T aylor personnel during the initial set up of the truck. aylor personnel during the initial set up of the truck. It may be necessary to adjust these settings It may be necessary to adjust these settings
over time due to over time due to component wear or replacement. component wear or replacement. These values are acc These values are acc essed through the operational essed through the operational
display, via the adjust groups. display, via the adjust groups.
Perform the following procedures to adjust the settings: Perform the following procedures to adjust the settings:
https://www.forkliftpdfmanuals.com/