Taylor TX180S, Maintenance Manual

Page: 195 / 320

11-1 11-1 TX / TXH / TXB 180S - 400L (Rev. 4/23/07) TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
Introduction. Introduction. The drive shaft connects the trans- The drive shaft connects the trans-
mission to the mission to the drive axle. drive axle. It is important It is important to always to always
have the transmission in phase with the drive axle have the transmission in phase with the drive axle
(See the note below). (See the note below).
Lubrication Lubrication (Illustration 11-1) (Illustration 11-1) . . The drive shaft, The drive shaft,
universal joints and slip joints should be greased universal joints and slip joints should be greased
periodically (refer to the periodically (refer to the Preventive Maintenance Preventive Maintenance
chart in the chart in the Appendices Appendices for drive shaft compo- for drive shaft compo-
nents lubrication interval). nents lubrication interval).
NOTE: NOTE: When the trans When the trans mission to mission to axle drive shaft axle drive shaft
is installed, the cross is installed, the cross assemblies, on the drive assemblies, on the drive
shaft, must be align shaft, must be align ed as shown ed as shown in Illustration in Illustration
11-1. 11-1. If the flanges If the flanges are not aligned, reposit are not aligned, reposit ion the ion the
splines to bring splines to bring the flanges into the flanges into alignment. alignment.
If this is not followed, the drive shaft will be out of If this is not followed, the drive shaft will be out of
phase, and phase, and vibration and noise vibration and noise may occur. may occur.
Drive Shaft Bolts Inspection Drive Shaft Bolts Inspection (Illustration (Illustration 11-1) 11-1) . .
The bolts, which connect the drive shaft to the The bolts, which connect the drive shaft to the
brake disc and drive axle, should be checked for brake disc and drive axle, should be checked for
tightness periodically (refer to the tightness periodically (refer to the Preventive Preventive
Maintenance Maintenance chart in the chart in the Appendices Appendices for drive for drive
shaft bolts shaft bolts inspection interval). inspection interval). If tightening If tightening is is
required, apply a torque value of 110 ft-lbs (150 required, apply a torque value of 110 ft-lbs (150
N N
⋅ ⋅
m) to the bolts. m) to the bolts.
https://www.forkliftpdfmanuals.com/