Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 87 / 510

Coral IPx Office Installation Manual Hardware Installation Procedure
2-43
Eq
uipment Insta
llation
2
00
This section describes how to install the DC power supply card into its slot. The
IPx Office unit is shipped from the manufacturer with the AC power supply installed.
If a DC power supply is to be installed, remove the existing AC power supply and
insert the DC power supply in its place. See
Figure 2-25
and
Figure 2-26
for power
supply placement in the IPx Office unit.
1. Verify that the IPx Office is properly grounded. See
Ground Wiring, page
2-20 .
2. Turn OFF (downwards) the power switch on the PS Office AC power supply
card.
3. Remove the PS Office AC power supply card from its slot.
4. Verify that the power switch on the PS Office DC power supply card is OFF
(turned downwards). See
Figure 2-25
.
5. Grasp the power supply horizontally with both hands, fingers near the left and
right of the power supply near the front panel.
6. Align the two guide ridges located on the bottom panel of the power supply
(right and left) in the card edge guides. Slide the power supply gently but
firmly, until fully inserted into the unit.
7. Fasten the two M3 screws located on the left and right of the power supply
front panel, thus securing the card to the cage as well as grounding the unit.
.
...................................................................................................
12 Installing the DC Power Supply
Circuit cards contain static-sensitive circuitry and may be damaged or destroyed by
electro-static discharge (ESD). Always wear a static dissipating wrist strap connected to
the unit while handling circuit cards. See Figure 2-14 on page 2-26 . Hold circuit cards by
their edges and avoid touching contact surfaces. Handle with care and do not drop.
Electrical Hazard. If the power supply screws are not fastened to the unit, the power
supply unit will not be grounded and could be subject to hazardous voltages. Do not
proceed further until the screws have been fastened.