Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 97 / 510

Coral IPx Office Installation Manual Initial Power-up Tests
3-1
Po
wer S
upply T
est
3
3.1
Power Supply Test
This chapter provides information about connecting the power supply to the facilities
power supply.
The IPx Office can operate as an AC powered system or as a DC powered system.
„
For AC powered systems, see AC Powered Systems, page 3-1 , below.
„
For DC powered systems, skip to
DC Powered Systems, page 3-3
.
0
1. Verify that the cage ground wire is connected and the ground nut is tightened.
See
Ground Wiring, page 2-20
.
2. Verify that the power supply unit has been installed and the two removable
screws on the left and right side of the PS Office AC front panel are tightened.
3. Verify that the PS Office AC power switch is OFF (turned downwards).
4. Verify that the female connector of the AC power cord has been inserted into
the front panel socket of the PS Office AC power supply. See
Figure 3-1 .
5. Insert the male plug of the AC power cord into the line outlet or primary
power receptacle designated for the system.
6. Turn ON the PS Office AC ON/OFF switch.
7. Verify that the LED indicators on the front panel light as described in Chapter
2, Hardware Installation Procedure .
8. Turn OFF the PS Office ON/OFF switch.
Before proceeding, verify that the peripheral cards in the expansion cages of the
IPx Office system are only partially inserted into their respective card slots, with the
front side protruding approximately 1 inch (2.5 cm) from the front of the card cage.
...................................................................................................
1 AC Powered Systems