Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 101 / 510

Coral IPx Office Installation Manual Initial Power-up Tests
3-5
Co
mm
on
C
ont
ro
l T
est
3
3.2
Common Control Test
This section deals with the Common Control Test. This test checks that the system has
initialized properly and that the memory lithium battery is functional.
0
Control card initialization includes two stages:
„
Activating the power supply card and checking the LED indicators for
functionality
„
Checking the PI device for successful initialization.
The MCB Office control card layout is shown in Figure 8-1 .
Activating the Control Card
1. In the main cage and in the expansion cages, verify that the PS Office power
switch is in the OFF position (turned downwards).
2. Verify that all peripheral cards in the IPx Office unit are completely installed.
3. Verify that all peripheral cards in the expansion cages protrude from the cage
by approximately 1 inch (2.5 cm).
4. Verify that the SAU is attached to the connector on the right side of the IPx
Office main unit. See
Software Authorization Management, page 8-16
.
5. Verify that the IMC8 flash memory card and the compact flash memory disk
have been inserted into their respective drives located on the front panel of the
IPx Office unit. See
IMC8 Flash Memory Card, page 8-35
.
6. Attach the Program Interface (PI) device cable to the KB0 programming port
connector on the front panel of the IPx Office unit. Verify that the PI device is
configured to match the data rate, word length, parity, and stop bits of KB0.
Default settings for KB0 are
9600 bps, 8 data bit, no parity, and 1 stop bit .
7. Turn ON the power switch on the PS Office power supply on the rear panel of
the IPx Office unit.
...................................................................................................
1 Activating and Initializing the Control Card