Tadiran Telecom Coral IPx Office, Installation And Hardware Reference Manual, Page: 89 / 510

Coral IPx Office Installation Manual Hardware Installation Procedure
2-45
Eq
uipment Insta
llation
2
0
The Coral IPx Office can operate as an AC powered system or as a DC powered
system. For DC powered systems, skip to
DC Powered Systems, page 2-47 .
AC Powered Systems
This section describes how to connect the power wires to the IPx Office unit for AC
systems (when the PS Office AC power supply card is installed). See
Figure 2-26
.
1. Route the AC power cord from the AC power receptacle to the AC connection
of the PS Office AC unit.
For 115 volt operation, when the power supply cord is not factory-supplied
the cord should be selected as follows:
Use a UL Listed/CSA Labeled Cord Set consisting of a minimum 18 AWG,
Type SVT or SJT three-conductor cord, terminating in a molded connector
body. The cord should have an IEC CEE-22 female configuration on one
end, and a molded-on parallel blade grounding type attachment plug rated
15A, 125V configuration (5-15P), at the other end.
2. Do not insert the power cord into the AC receptacle at this time.
Figure 2-26 AC Power
Connection for One IPx
Office Unit
...................................................................................................
13 Connecting the Power Wires
Electrical Hazard. Verify that the AC power strip or outlet supplying the unit is easily
accessible and can be easily disconnected in the event of emergency. Verify that the
power strip or outlet is no higher than 64" (162.5 cm) from the floor.
slots 2 - 3
slots 4 - 5
slots 6 - 7
slots 8 - 9
slots 10 - 11
PS Office AC
Cat. No. 77440950200
OUTPUT:
+5V 6A
+3.3V 6A
DC
DC
DC
-48V 1A
INPUT:
100-240V 2.2A 50/60Hz
AC
ON
OFF
To AC
power outlet