-Shenzhen Guanhong Automation Co.,Ltd.-
SZGH-CNC1000MDb Series
- 129 -
Rotation of tool in
JOG
Tool magazine rotate CW/CCW, stop until detect T08
(count of tool),which only works on MDcb series
Rapid mode
Holding Rapid key+ Manual Feeding Key, for feeding
with rapid speed manually. When P38=8 in Other
parameter,the key is set to switch of Rapid/Normal.
Manual Feeding Key
For positive/negative movement of X, Y, Z, A
& B axes in MANUAL mode
Cycle Start Button, for run processing program on Auto, or run MDI
Pause Button, for halt processing
Note:only E type operational panel has Pause button.
Emergency stop Driver and motor stop immediately, turns off the spindle,
coolant, waits for the rise of button, and initializes values
Interface Switch
Left side: Normal Mode
Middle: F-Halt , stop feeding
Right side: FS-Halt, stop feeding & rotation of spindle
Handwheel on panel for feeding manually.
P1=0 in Other parameter is select handwheel on panel.
Note: only A type & C type operational panel have handwheel(MPG).
Power On/Power OFF switches
Note:Only C type & E type operational panel have these switches.
Using solution , please check chapter 6.7.2
Note: 1.“Manual speed controlled”: Press “1” “2” “3” “4” “5” “6” “7” “8” “9” to set feed override “F30”
“F60” “F120” “F250” “F500” “F1000” “F1500” “F2000” “F2500” “F3000”.
2.“Incremental coordinate”: Press “Setup” to set or set to 0 after enter “relative” coordinate mode.
3. Machine coordinate clear: Press “E” in parameter and then press “Enter”.
4. “F”: Taking mm/min as the unit to set the manual feed speed, the input range is from 1 to
30000mm/min. And the input method according to data input method in parameter.
5.“S”: Set the speed of the first spindle. The range is from 0 to 99999, the max depends on the No.36
parameter in speed parameter.
6.“I”: Modify the increment per step in manual increment mode
7. "T": Choosing the position cutting tool.
