SWM RS 125 R 2016, Manual, Operation, Maintenance

Page: 84 / 308

1
N
5
3
4
2
EN - 22
STARTING THE ENGINE
- Set ignition key (1) in “ ” position (the buzz
that you hear when you turn the key to “ ” is
caused by the fuel pump which puts the feeding
system under pressure);
- pull the clutch lever (2);
- shift the gear pedal (3) into neutral position;
- Check that the button (4) is in the out position
and press it, followed by the start button (5).
NOTE
When starting with an already warmed up engine
DO NOT USE the starter. When a cold engine has
just been started, do not increase revs, to ensure
an adequate oil warm-up and circulation.
NOTE
A safety switch is set on the clutch lever support.
This switch allows you to ONLY start the engine
with the gearbox idle, or with the gear engaged
and the clutch lever pulled.
and the clutch lever pulled.
With the stand lowered, the bike can only be start-
ed with the gear in neutral.
IMPORTANT NOTE IN CASE OF COLD STARTS AT
LOW TEMPERATURES
It is recommended to briefly warm up at idle speed
until you get a normal engine response to the ac-
celerator openings.
In this way the oil can reach all the surfaces needing
lubrication and the coolant will reach the necessary
temperature for correct engine function.
Avoid overheating the engine.
IMPORTANT*: Never accelerate the engine af-
ter a cold start.
WARNING*: Exhaust contains poisonous car-
bon monoxide gas. Never run the engine in a
closed garage or in a confined area.