AUTOMATIC TRANSMISSION (4 A / T)
7B1-115
43) Install adapter case (1) with new adapter gasket to transmis-
sion case and tighten adapter case bolts to specified torque.
Tightening torque
Adapter case bolt (a): 35 N
.
m (3.5 kg-m, 25.5 lb-ft)
44) Apply A / T fluid to new O-ring and install it to output shaft speed
sensor (1) and then install output shaft speed sensor (1) to
adapter case (2).
Tightening torque
Output shaft speed sensor bolt (a):
7.5 N
.
m (0.75 kg-m, 5.5 lb-ft)
45) After turning manual shift shaft fully rearward, turn it back by 2
notches and set it to “N” range. Then install transmission range
sensor, lock washer and set nut and tighten set nut. After tight-
ening it, bend claws of lock washer.
Tightening torque
Manual shift shaft set nut (a):
4 N
.
m (0.4 kg-m, 3.0 lb-ft)
46) With neutral reference line (1) and cut groove (2) in sensor
aligned, tighten lock bolt.
Tightening torque
Transmission range sensor lock bolt (b):
5.5 N
.
m (0.55 kg-m, 4.0 lb-ft)
47) Confirm that torque converter is fully fitted in transmission.
Confirmation can be done by measuring dimension between
end surface of housing case (2) and drive plate installation
seat.
Standard dimension between end surface of case housing
and drive plate installation seat “a”:
56.4 mm (2.22 in.)
48) Check that torque converter turns smoothly and apply grease
to center piece (1) of torque converter.
