7B1-90
AUTOMATIC TRANSMISSION (4 A / T)
1. Thrust bearing
No.2 race
2. Thrust forward
clutch bearing
3. Thrust rear race
INSTALLATION
1) Apply A / T fluid to forward input shaft O-rings, install forward
clutch piston and piston return spring (2) to forward input shaft
and then install return spring ring with special tool and hydraulic
press.
Special tool
(A): 09926-98310
NOTE:
D
When installing return spring (2), be careful so that return
spring (2) will not fall or tilt.
D
Do not align opening in retaining ring (1) with lug of for-
ward clutch piston return spring (2) at its retainer section.
CAUTION:
Be careful when applying pressure, for overpressure will
cause plate section of piston return spring to deform.
NOTE:
D
Refer to the first figure of “FORWARD CLUTCH” in this
section. When installing each component.
D
Do not match opening in retaining clutch ring and dent in
forward clutch input shaft.
2) Install bearing races and thrust bearing.
3) Install forward clutch hub (3), direct clutch hub (2) and retaining
ring (1) to input shaft (4) in that order.
