7B1-74
AUTOMATIC TRANSMISSION (4 A / T)
14) Remove rear mounting (1) by removing its bolts (2).
NOTE:
If automatic transmission is overhauled later on, draining
A / T fluid at this point will facilitate work.
Tightening torque
A / T fluid drain plug (a): 20 N
.
m (2.0 kg-m, 14.5 lb-ft)
15) Lower the transmission jack slowly. Remove it from the trans-
mission, then install the auxiliary arm (2) to the transmission
jack (1).
16) Raise the transmission jack until it touches the transmission.
17) Disconnect connectors from VSS, output shaft speed sensor,
input shaft speed sensor, transmission range sensor, shift &
TCC solenoid valves and other electrical parts, and release
their wire harness from clamps.
18) Remove breather hose and harness clamp mounting bolt from
transmission.
19) Remove oil filler upper tube by removing its bolts.
20) Remove engine to transmission bolts and nuts.
21) With transmission assembly held up on jack, move them to the
rear and lower them including torque converter.
As necessary, insert a rod into the gap between the drive plate
(1) and the torque converter (2), then separate the driver plate
(1) from the torque converter (2).
WARNING:
Transmission assembly may tilt rearward on jack. It is
recommended to use an auxiliary arm of jack for the
purpose of safety.
