ENGINE MECHANICAL (RHZ ENGINE)
6A3-49
INSTALLATION
1) Lower engine assembly into engine compartment.
2) Tighten engine side mounting bracket nuts (R & L).
Tightening Torque
(a): 50 N
.
m (5.0 kg-m, 36.5 lb-ft)
3) Remove lifting device.
4) Reverse removal procedure for installation, noting following
points.
CAUTION:
Before installing intake air pressure sensor hose, de-
grease connect part of hose and intercooler outlet hose.
Otherwise hose may become detached and cause turbo
system failure.
D
Install transmission assembly referring to Section 7A or 7B.
D
Adjust generator belt tension, referring to Section 6H.
D
Adjust A / C compressor belt tension, if equipped. Refer to Sec-
tion 0B.
D
Check to ensure that all removed parts are back in place. Rein-
stall any necessary parts which have not been reinstalled.
D
Refill engine with engine oil, referring to item “ENGINE OIL
CHANGE” in Section 0B.
D
Refill cooling system referring to “ENGINE COOLING” sec-
tion.
D
Check to make sure that there is no fuel leakage, coolant leak-
age and exhaust gas leakage at each connection.
