[LH]
[RH]
Differential side
FRONT DRIVE SHAFT / SHAFT BEARING, OIL SEAL
4A2-3
6) Install circlip (1) by using snap ring plier.
7) Apply grease to entire surface of cage.
Use joint grease in tube included in spare part.
8) Insert cage into outer race and fit circlip (1) into groove of outer
race.
CAUTION:
Position opening of circlip “a” so that it will not be lined
up with a ball.
9) Apply grease in tube included in spare part to inside of outer
race, and fit boot to outer race.
Fill up inside of boot with joint grease.
“A”: Joint Grease (about 90 – 100 g / 3.2 – 3.5 oz)
10) Fitting boot to outer race, adjust so that measurements “b” and
“c” become as indicated in figure.
Length“b”: 203.2 – 213.2 mm
(8.00 – 8.40 in.) (for A / T vehicle)
196.8 – 206.8 mm
(7.75 – 8.14 in.) (for M / T vehicle)
“c”: 125.5 – 135.5 mm
(4.94 – 5.33 in.) (for A / T vehicle)
127.5 – 137.5 mm
(5.02 – 5.41 in.) (for M / T vehicle)
Before fixing boot band, insert screwdriver into boot on joint
side and allow air to enter boot so that air pressure in boot be-
comes the same as atmospheric pressure.
11) Clamp boot band. Check boots for distortion or dent.
