7A2-44
MANUAL TRANSMISSION
4) Align key slot of high speed synchronizer hub and protrusion of
synchronizer ring and set input shaft assembly to main shaft as-
sembly. Check that input assembly turns lightly.
5) Install counter shaft (1) and counter shaft bearing outer race (2)
to intermediate case.
NOTE:
D
When installing bearing, bring it so that its C-ring side is
at rear side of intermediate case as shown in the figure.
D
When fitting of intermediate case and bearing is tight, tap
outer race of bearing lightly and evenly with plastic ham-
mer.
6) Fix bearing with new C-ring (1) by using special tool.
Special tool
(A): 09900-06107
7) Install main and counter shaft bearing retainer (1).
“A”: Cement 99000-32110
Tightening torque
Main and counter shaft bearing retainer screws (a):
19 N
.
m (1.9 kg-m, 14.0 lb-ft)
