6A3-40
ENGINE MECHANICAL (RHZ ENGINE)
A: Crankshaft pulley side
B: Flywheel side
A: Camshaft pulley side
3) Install knock pins (1) to cylinder block.
4) Install new cylinder head gasket (2) to cylinder block.
Thickness identification notch(es) (3) provided on gasket should
come to oil filter side.
5) Check to make sure that length of cylinder head bolt as shown
in figure does not exceed specified value.
“a”: Less than 133.4 mm (5.25 in.)
6) Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
a) Tighten all bolts to 20 N
.
m (2.0 kg-m, 14.5 lb-ft) according to
numerical order in figure.
b) In the same manner as in Step a), tighten them to 60 N
.
m
(6.0 kg-m, 43.5 lb-ft).
c) Retighten all bolts 220
_
according to numerical order in fig-
ure.
7) For installation, reverse removal procedure noting the following.
D
Install turbocharger bracket bolt (1). Tighten bolt to specified
torque.
Tightening Torque
Turbocharger bracket bolt (a): 30 N
.
m (3.0 kg-m, 22.0 lb-ft)
D
Using new gaskets, connect oil return pipe (2) and lubrication
pipe (3) to turbocharger. Tighten bolt to specified torque.
Tightening Torque
Lubrication pipe union bolt (b): 20 N
.
m (2.0 kg-m, 14.5 lb-
ft)
