Steris SYSTEM 1E, Maintenance Manual

Page: 27 / 179

2-7
764333-675
VALVES INPUT
CONSOLE MORE
Select CONSOLE , then press SAVE VALUES touch
pad.
Display shows:
KEYPAD DIPSW
DISPLAY
• DIP SW (Dip Switch)
NOTE: Only NOSHOK used. Ametek - IPTG and
Ametek - MPTG information shown for reference only.
Select DIP SW , then press SAVE VALUES touch pad.
Display shows:
1234
1111
The 1234 indicates the control board dip switch
position and number directly below indicates status of
the switch. 1 indicates OFF, and 0 indicates ON.
The dip switch definitions are as follows:
• Position 1 and 2 – select model of pressure
transducer. Check Transducer Model No.:
• Position 3 – direction of the printer (0= print from
bottom up; 1= print from top down; 1 is default
setting.)
• Position 4 – printer self test mode (0= test mode; 1=
normal operation). Printer prints: **THIS IS A
SELF TEST**. Access dip switch through cover
panel on backside of control panel. Locate plug
button and remove. Use a small plastic screwdriver
or pen to activate switch.
Select CANCEL . Display shows:
MFG TESTS
VALUES CALIB
Select TESTS , then press SAVE VALUES touch pad.
Display shows:
VALVES INPUT
CONSOLE MORE
Select
CONSOLE
, then press
SAVE VALUES
touch
pad. Display shows:
KEYPAD DIPSW
DISPLAY
• Display
Select DISPLAY , then press SAVE VALUES touch
pad. Display shows:
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
The display responds by lighting up all pixels in
display. Inspect display for burned out pixels. Select
CANCEL . Display shows:
MFG TESTS
VALUES CALIB
Select TESTS , then press SAVE VALUES touch pad.
Display shows:
VALVES INPUT
CONSOLE MORE
• More
Select MORE , then press SAVE VALUES touch pad.
Display shows:
Position 1: Position 2: Trans. M/N:
1(off) 1(off) NOSHOK
0(on) 1(off) Ametek - IPTG
1(off) 0(on) Ametek - MPTG