Sparc S7-2L, Service Manual

Page: 145 / 160

Remove the Rear Drive Backplane
e.
Reconnect the power cords to the power supplies, and power on the server.
See “Attach Power Cords” on page 154 and “Power On the Server (Oracle
ILOM)” on page 154 or “Power On the Server (System Power Button)” on page 155 .
Verify that the power supply AC OK LED is lit.
Note -
Authorized service personnel might need to reprogram the product serial number on
the drive backplane. This number is used for service entitlement and warranty coverage. The
correct product serial number is located on a label on the front of the chassis.
5.
Use the Oracle ILOM
show faulty
command to verify that the fault has been
cleared.
See “Identify Faulted Components” on page 28 for more information on using the
show faulty
command.
Remove the Rear Drive Backplane
1. Prepare the server for service.
See “Preparing for Service” on page 45 .
2. Pull each rear drive out far enough to disengage it from the rear drive backplane.
3. Disconnect the cables from the rear drive backplane (panel 1).
a. Disconnect the two SAS cables from the rear drive backplane.
Servicing the Drive Backplane 145