Sparc S7-2L, Service Manual

Page: 134 / 160

Install the Eight-Drive Backplane
4.
Using a No. 2 Phillips screwdriver, loosen the right-side spring-mounted screw
(on the power supply side of the server) that secures the drive backplane to the
chassis (panel 4).
5. Lift up on the left-side spring tab, and then gently release the drive backplane
from the standoff hooks and out from under the spring tab (panel 5).
6. Pull the drive backplane away from the standoff hooks and spring tab and out of
the chassis (panel 6).
7. Place the drive backplane on an antistatic mat.
Related Information
■
“Internal Component Locations” on page 20
■
“Install the Eight-Drive Backplane” on page 134
Install the Eight-Drive Backplane
1. Lower the drive backplane into the server, and then position it under the spring
tab to engage the standoff hooks.
The standoff hooks fit into small openings in the drive backplane.
Ensure that ribbon cables are clear of the drive backplane.
2. Using a No. 2 Phillips screwdriver, install and tighten the spring-mounted screw
(on the power supply side of the server) to secure the drive backplane to the
chassis.
3. Reconnect the cables to the drive backplane.
a. Reconnect the auxiliary signal cable to the drive backplane.
b. Reconnect the power cable to the drive backplane.
c.
Reconnect the two NVMe cables to the drive backplane.
Attach connectors to the original locations on the drive backplane.
d.
Reconnect the two SAS cables to the drive backplane.
4.
Return the server to operation.
134 SPARC S7-2L Server Service Manual • March 2017