Sparc S7-2L, Service Manual

Page: 154 / 160

Attach Power Cords
If the CMA is in the way, disconnect the left CMA release and swing the CMA open. See
“Release the CMA” on page 56 .
4. Reconnect the CMA.
Swing the CMA closed and latch it to the left rack rail. Refer to “Attach the CMA to the
Server” in SPARC S7-2L Server Installation Guide .
Related Information
■
“Remove the Server From the Rack” on page 58
■
“Attach Power Cords” on page 154
Attach Power Cords
1.
Attach both power cords to the power supplies.
Note -
As soon as the power cords are connected to a power source, standby power is applied in
the server. Depending on how the firmware is configured, the server might boot at this time.
2. Power on the server.
See “Power On the Server (Oracle ILOM)” on page 154 or “Power On the Server (System
Power Button)” on page 155 .
Related Information
■
“Power On the Server (Oracle ILOM)” on page 154
■
“Power On the Server (System Power Button)” on page 155
Power On the Server (Oracle ILOM)
Note -
If you are powering on the server following an emergency shutdown that was triggered
by the top cover interlock switch, you must use the
poweron
command.
Type this command at the Oracle ILOM prompt.
-> poweron
You will see an
alert
message on the system console. This message indicates that the server is
reset. You will also see a message indicating that the VCORE has been margined up to the value
specified in the default
.scr
file that was previously configured. For example:
154 SPARC S7-2L Server Service Manual • March 2017