100
Configuring System Settings ([System Setup] menu)
S
e
tti
n
g
s
[PGM OUT]:
Select this checkbox when you want to
output the audio of channel faders 1 to 5 to PGM
OUT.
[MIX OUT]:
Select this checkbox when you want to
output the audio of channel faders 1 to 5 to MIX OUT.
[MIC/LINE]
Adjust the mic/line levels when the input audio signal is
too large or too small.
Configure the mic/line levels after selecting an audio
input connector.
[MIC/LINE Level]:
Select [High (+4dB)], [Middle
(-20dB)], or [Low (-44dB)] while using the base level
of the input device as a reference.
The mic/line levels can only be configured for [MIC/
LINE 1] to [MIC/LINE 4].
[Output]
Adjust the PGM OUT and MIX OUT delays so that the
video and audio matches.
[PGM Delay]:
Adjust the delay time for PGM OUT.
Drag the slider, and adjust the delay time within a
range of 0 to 7.5 frames (0.25 increments).
[MIX Delay]:
Adjust the delay time for MIX OUT.
Drag the slider, and adjust the delay time within a
range of 0 to 7.5 frames (0.25 increments).
[OSC (Oscillator)]
Configure settings for outputting oscillator signals that
will be sued for adjustments.
[OSC Freq.]:
Select the oscillator frequency.
Select [Off] (disable oscillator), [100Hz], [1kHz], or
[10kHz].
[OUT Level]:
Adjust the output level of the oscillator
signal.
Drag the slider to adjust within a range of –
∞
to
0 dBFS.
[OSC OUT]:
Select the checkbox of the output
destination for the oscillator signal.
[Others] Screen
Configure settings such as those for AUX, remote
cameras, [PGM] and [NEXT] viewer positions, and
transition rates.
The following items are available in the [Others] settings.
[Customize GUI]
Switch the display positions of the [PGM] viewer and the
[NEXT] viewer, and specify whether to display tallies in
the [Input] list.
[PGM Viewer Position]:
Select whether to display the
[PGM] viewer in the upper or lower position.
•
[Upper]:
Display the [PGM] viewer in the upper
position.
•
[Lower]:
Display the [PGM] viewer in the lower
position.
[Tally]:
Specify whether to display tallies for the sources
in the [Input] list.
•
[Off]:
Disable display.
•
[On]:
Enable display.
Audio input connectors
Item
Description
Reference
AUX
Configure this if necessary when
outputting AUX.
GPI
Configure settings for using GPI
output to light the tally lamps on
the cameras being used as the
PGM output and NEXT selection
sources.
Remote
Camera
Configure this to perform remote
controls for VISCA-compatible
cameras.
Customize
GUI
Switch the display positions of
the [PGM] viewer and the
[NEXT] viewer, and specify
whether to display tallies in the
[Input] list.
Transition
Rate
Configure the selectable options
for the transition rate in the main
screen.
Summary of Contents for AWS-750
Page 121: ......
