31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
12/109
1.4.2. Checking the Outside Sensor Box connection
COMM
LED
1.4.2.1. COMM LED (RS 485 sensor bus)
Connection
LED State
Outside Sensor Box
COM: yellow, blinking
2.
Software Installation
2.1. Required software
Before you start with the configuration of the project, you must install the following software on your
computer:
•
Framework.NET 1.1 (for ETS3 Plug in)
•
Framework.NET 3.5 (for animeo KNX Operating Software)
•
animeo KNX Operating Software (see accompanying CD), Version 2.0 or later
•
Licensed ETS 3.0 and the following or higher version
•
WAGO Ethernet Settings (see accompanying CD)
3.
Setting the PC IP address
To enable communication between the computer and animeo KNX Master Control via the TCP/IP, you
must assign to the computer an IP address in the same subnet as with the animeo KNX Master Control.
The IP address/subnet mask of the animeo KNX Master Control is in the delivery state
192.168.0.2/255,255.0.0.