31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
51/109
4.7.1.1. Wind
Using the wind function, it can be ensured that the end products do not become damaged by wind. If
one of the assigned wind sensors measures values above the defined threshold value for wind speed,
the corresponding KNX object (KNX.MC.Zone_Security_High_Prio_Bit_OUT) will transmit “1”.
This function is not available for end products in an inside zone.
Parameter:
1. Select wind function.
2. Enable/disable function.
3. Allocate wind sensor. All sensors are displayed in the list. Wind sensors are assigned to the select-
ed zone by clicking the control box. At least one sensor must be assigned.
4. Threshold value wind speed
necessary measured wind speed to trigger the function. The value
of the maximum fixable set value is dependent on the type of end product.
5. Response time
time span, in which the wind speed must exceed the threshold value (4), before
the wind function is activated.
6. Delay time
time span, how long the wind speed must be below the threshold value (4), before the
wind function is deactivated.
7. Use KNX Object Low Prio
only active in use with wind direction (chapter 4.7.1.2.1.).