31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
55/109
4.7.1.4. Shadow Management
With help of the Shadow Management, end products move to given positions. When the sun threshold
exceed the on set values and when the zone is not in shade according to the shadow calculation, made
by the shadow device, then the end products will move down. When the zone is in shade according to
the shadow calculation, the end products move to the ON position.
This function is only carried out when there is no other function with a higher priority active. The corre-
sponding KNX objects are KNX.MC.Zone_Position_UP_DOWN_1Byte_OUT,
KNX.MC.Zone_Slat_Position_1Byte_OUT and KNX.MC.Zone_Sun-Function_Bit_OUT.
Parameter:
1.
Enable/disable Shadow Management
2.
Select shadow zone number from the “Shadow Device“
4.7.1.5. OFF Position
If the sun intensity falls below the adjusted sun off threshold (1), then the end product will move into the
defined OFF Position. Click on the button OFF Position (2) to adjust it.
This function is only carried out if no other function with a higher priority is active. The corresponding KNX
objects are KNX.MC.Zone_Position_UP_DOWN_1Byte_OUT, KNX.MC.Zone_Slat_Position_1Byte_OUT ,
and KNX.MC.Zone_Sun-Function_Bit_OUT.