![background image](http://html.mh-extra.com/html/somfy/animeo-knx-master-control-w2/animeo-knx-master-control-w2_manual_1317463045.webp)
31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
45/109
g. Frost/ice: The Frost alarm is triggered at temperatures below the threshold value. All end prod-
ucts in a zone go to the safety position (chapter 4.7.1.8).
h. Rain: With an active function all end products in a zone go to the safety position (chapter
4.7.1.8).
5. Non-safety functions
a. Manual service through PC: The function becomes active if manual command is entered over
the KNX Operating Software a. (chapter 4.6.1).
b. Timer: With activation the zone goes in the given position and angle (chapter 4.7.2ff).
c. Block Heat: Upon activation, heat is retained by means of the sun screen from the building, for
example, the sun protection is moved into the position of 100 % (section 4.7.3.3.).
d. Heat by the sun: With activation the zone uses solar energy for warming, for example, the sun
protection is driven in 0 % position (chapter 4.7.4.1).
e. Heat retention: With activation the zone saves the caloric energy, for example, the sun protec-
tion is driven to the 100 % position (chapter 4.7.4.2).
f. Ventilation Cooling: When activated the area uses the natural ventilation for cooling of the
building, for example, windows are opened automatically (chapter 4.7.3.4.).
g. Sun: Active with excess of the threshold value for solar intensity. The zone goes in the defined
position (defined or according to sun tracking) (chapter 4.7.1.3).
i. Sun: Active when the threshold value for sun intensity is exceeded. The zone moves in the
defined position (determined according to sun tracking) (Chapter 4.7.1.4).
ii. Shadow Management: Active when the threshold value for sun intensity is exceeded. The
zone, according to the “Shadow Device” is in the defined position. The zone moves in the
defined OUT position (Chapter 4.7.1.4).
6. Information safety functions
7. Information non-safety functions
4.5.2. Sensor status
In the navigation bar click on “status” and then on “sensors”.
In the register “sensors: wind, sun, rain” the sensor values are indicated which are directly in the KNX
Master Control or are connected via the Outside Sensor Box.