![background image](http://html.mh-extra.com/html/somfy/animeo-knx-master-control-w2/animeo-knx-master-control-w2_manual_1317463074.webp)
31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
74/109
4.7.3.2. Maintain heat
This function enables heat to be kept in the building with the help of the sun protection. This function is
normally used after working hours.
If the indoor temperature and the sun brightness are lower than the set value and the outside tem-
perature lies under 5°C, the sun protection hangings move to a predefined position. This function is only
carried out if no other function with higher priority is active.
The corresponding KNX objects are KNX.MC.Zone_Energy_Saving_Bit_OUT[n],
KNX.MC.Zone_Position_UP_DOWN_1Byte_OUT[n] and KNX.MC.Zone_Slat_Position_1Byte_OUT[n]
whereby “n” stands for the corresponding zones 1-16.
2
1
3
4
5
6
7
8
Parameter:
1. Select Maintain Heat.
2. Enable/disable function.
3. Response time
time span, during indoor temperature (5) falls below and sun rays (6) must exceed
before the function is activated.
4. Delay time
time span, during the indoor temperature (5) must be exceeded and sun rays less than
(6) before the function is deactivated.
5. Indoor temperature
the necessary measured indoor temperature which must be exceeded or be
below to activate or deactivate the function.
6. The sun
the necessary measured sun intensity which must be exceeded or be below to activate
or deactivate the function.
7. Position, to which is moved to with activating the function (2).
8. Angle, to which is moved to with activating the function (2).