![background image](http://html.mh-extra.com/html/somfy/animeo-knx-master-control-w2/animeo-knx-master-control-w2_manual_1317463105.webp)
31. March 2017
Manual
animeo KNX Master Control W2/W8
2011-2017, SOMFY ACTIVITES SA ALL RIGHTS RESERVED 2017/03/31
105/109
Now enter in the field “Configuration Data“ under IP Address, the new desired IP address and likewise
the subnet mask and confirm the entry with “Submit”.
Click on “SUBMIT” to apply the changes in your fieldbus node. Restart the fieldbus node to apply the
settings of the Web interface.
7.2. Assigning IP Address via Address
Selection Switch
Use the address selection switch to set the host ID, i.e. the last byte of the IP address, which is en-
tered in the web-based Management System on WBM page “TCP/IP”, entry “DIP switch IP-Address”,
with values between 1 and 254 binary coded.
Example:
DIP switch IP address: 192.168.7
Set DIP switch value: 50 (binary coded: 00110010)
7.3. Resulting IP address saved in the fieldbus
controller: 192.168.7.50
The base address used consists of the first three bytes of the IP address. This always depends on the
DIP switch IP address currently saved in the fieldbus controller.
If there is still no static IP address in the fieldbus controller, the default value 192.168.1 defined by the
firmware as the base address is used when setting the DIP switch to 1 - 254.
1. The setting of the address selection switch then overwrites the value of the host ID.
To configure the IP address via the address selection switch by setting the host ID (last position of
the IP address) to a value that does not equal 0/255, first convert the host ID to the binary repre-
sentation.
For example, host ID 50 results in a binary code of 00110010.
2. Set the bits in sequence using the 8 address switches. Start with address switch 1 to set bit 0
(LSB) and end with address switch 8 for bit 7 (MSB).
3. Restart the fieldbus coupler after adjusting the address selection switch to apply the configuration
changes.