Somati system FSTronic IRC-FI, Manual

Page: 34 / 44

www.somati-system.cz
34
11.3. Safety instructions for hermetic Pb batteries
 It is important to maintain correct polarity – do not switch the poles, keep contacts clean.
 Use them only for electrical appliances, which they are intended for.
 Hermetic Pb batteries cannot be replaced by common car or motorcycle batteries.
 If the battery is overcharged during using the original charger, the charger is damaged.
Immediately stop using the defective charger and hand the charger over to professional
service for repair.
 For charging the PB batteries it is not possible to use chargers for common
car and motorcycle batteries or chargers for NiCd, NiMh or other types
of batteries.
 Protect the batteries against short-circuit, do not overload or heat the batteries,
do not throw them into fire, do not open, deform or damage them.
 Hand the old batteries in to the collection place.
If the batteries are damaged by improper use or by failure to follow principles
mentioned above, the warranty cannot be applied! To determine the cause of battery
fault in order to claim warranty, the seller reserves the right to test the conditions
of the operation. If im- proper conditions are found out, the work connected
with the control and measurement of the conditions will be charged.
12.
Circuit diagrams
12.1. FSTronic IRC-FI – Basic connection terminal X4
12.2. FSTronic IRC-FI – control board DPS
12.3. FSTronic IRC-FI – motor with IRC sensor
12.4. FSTronic IRC-FI – connection of smoke/heat detectors
12.5. FSTronic IRC-FI – battery module
12.6. FSTronic IRC-FI – connection of safety edge OSE + safety sensor passage door
12.7. FSTronic IRC-FI – connection of different types of light curtains
12.8. FSTronic IRC-FI – connection of optocell, connection of safety sensor gate lock