Somati system FSTronic IRC-FI, Manual

Page: 26 / 44

www.somati-system.cz
26
6.2. Indication of the end of service intervals
Control box FSTronic is equipped with internal memory, which displays end of pre-set
service interval by simultaneous and synchronized flashing of all diodes. Standard interval
is pre-set on 3000 cycles (see setting of parameter
) or 1 year (see setting of parameter )
from the last service (or putting into operation). In case of the signalization of the end of service
interval it is necessary to contact service organization to do the service inspection. After the
inspection of gate, control is set into the standard operation mode again. Even when
signalization of the end of service interval is activated, all control functions stay unchanged
– only displaying of alarms is affected by synchronized flashing of service interval.
7.
Value report on the functional display
Little LED in bottom right corner quickly flashes (nearly
continuously ON) acording to the communication with encoder
in the motor. If flashes with interruptions than communication is
incorrect – in this case check connection of communication cabel
or setting DIP7.
If sign STOP quickly flashes then is disconnected input X2:+,
X2:5 or is pressed button STOP on the keyboard - this blocks movement of the gate.
If gate is in STOP mode (no movement) it is possible by turning knob display
another information values as described in 6.1 and following:
Indication from end switch DES 2B hexa – (e.g. 6Hr2).
Indication of voltage on low voltage circuit. In case of connected batteries
indicated voltage on battery. A 24.2 = 24.2 V
7.1. Základní stavy zobrazované na displeji
 After reset.
 After reset it initializes.
 Stop. If flashes see point 7.
 searching refernce point in closed possition
 searching refernce point in opened possition
 Opening.
 Closing.
 „Time open“ calibration of opening time – only during the setting.