Somati system FSTronic IRC-FI, Manual

Page: 29 / 44

www.somati-system.cz
29
8.
Errors on frequency inverter
List of errors on frequency invertor - see manual of the invertor YASKAWA AC V1000.
In case of fault “OC” (over current) or “SC” (short circuit) immediately disconnect motor
cable and check if there is not short circuit.
If this fault is repeated also when the motor cable is disconnected then the frequency
inverter is damaged.
9.
Connectors
9.1. Connectors on DPS - (terminal block X1)
4-10 free without functions
13, 14 „safety brake“ – input for door lock sensor
PE, N, LP, L1, L2, L3 internal connection in unit
9.2. External - terminals on DPS in the contr. box (terminal
block X2)
a)
Input side (upper part of the terminal block X2)
Terminals marked „+“ are common – (+24 V), inputs are activated by connecting to„+“
OSE – optical safety edge
+ (B)
+12V (brown receiver and transmitter)
- (W) 0V (white receiver and transmitter)
O(G) output (green receiver and transmitter)
1 +24 V
-
0 V
2
+
3
+
+
+
+
+
to power safety sensors and external devices
to power safety sensors and external devices
“LOWER INFRA” - NC contact of safety sensor for closing
+24 V
„UPPER INFRA” - NC contact of safety sensor for opening
– against closing.
It also serves to connection of safety sensor of
passage door – i.e. always during operation and disconnection of
the contact, gate closes (without moving back)
+24 V
OPEN – NO contact
+24 V
STOP - NC contact.
NOTE: Used only as input STOP, do not connect
any functional blocking of the drive. Functional blocking connect
only to input “upper infra
+24 V
CLOSE – NO contact
+24 V
PULL SWITCH STEP-BY-STEP - NO contact
+24 V
4
5
6
7