Somati system FSTronic IRC-FI, Manual

Page: 25 / 44

www.somati-system.cz
25
6.
Counter of cycles on control panel
Control box FSTronic has built-in internal memory, from which it is possible to display
the state of performed cycles of gate. Counter supplied after installation is reset. After change
of some components (e.g. motor) or after the complete overhaul of mechanical device
of gate, it is possible to reset the counter values– this operation can be done only by a trained
service technician, who is entitled to do the operation (it is necessary to record that into the gate
service book).
6.1. Displaying counter values
If the gate is in Stop state, it is possible by turning the knob button to display individual cycle
values one by one:
Operating counter – from putting into operation
P ̄ XX = operating counter XX -- --
P - XX = operating counter -- XX –
P ˍ XX = operating counter -- -- XX
Alarms counter - from last service
A ̄ XX = service counter XX -- --
A - XX = service counter -- XX --
A ˍ XX = service counter -- -- XX
Service counter cycles – from last service
221133
cycle
amount
221 alarm
amount
12536 cycle
amount
from last
service
Service counter time – from last service
t ̄ XX = service counter XX -- --
t - XX = service counter -- XX –
t ˍ XX = service counter -- -- XX
1536 days
amount
from last
service
!
Note: Reset can be done only by trained service.
!
How to reset: Press button up + down at once for 10 seconds. All diodes will
shortly flash - signal for successful reset done.
S ̄ XX = service counter XX -- --
S - XX = service counter -- XX --
S ˍ XX = service counter -- -- XX