MV-805 IP Multiviewer User Manual
Introduction to the RollCall MV-805 Template Screen
RollCall Templates 6.1
Issue1 Revision 1
Page 48
© 2018 SAM
Template Selection:
The following MV-805 RollCall template screens may be selected in the
Template Selection
box by clicking on the template name:
System Status:
The
System Status
box displays the multiviewer system status at the top of each template:
•
OK - the multiviewer is working correctly.
•
Fail - the multiviewer has a problem.
•
Starting: The template is being filled out with information read from the MV-805.
Wait until the message disappears before interacting with the template.
•
Restart Required: This is shown after a setting has been changed on the template and
the unit requires a restart to make the setting change take effect.
•
System Restarting.
•
System-Setup:
See Section 6.2 “System-Setup Template” on page 49
•
Layout
:
See Section 6.3 “Layout Template” on page 63
•
TSL
:
See Section 6.4 “TSL Template” on page 64
•
Timer Control
:
See Section 6.5 “Timer Control Template” on page 66
•
Timer Request Protocol:
See Section 6.6 “Timer Request Protocol Template” on
page 68
•
Destination Spigot:
See Section 6.7 “Destination Spigot Template” on page 69
•
Source Spigot:
See Section 6.8 “Source Spigot Template” on page 73
•
Reset:
See Section 6.9 “Reset Template” on page 76
Figure 26 Example System Status Box Messages:
a) OK.
b) OK, but settings changes are pending that require a system restart.
c) System restarting.
a) System is OK.
b) System is OK, but some settings changes are pending that require a system restart.
c) System is restarting.
