MV-805 IP Multiviewer User Manual
Unit Shutdown
Hardware Installation 5.6
Issue1 Revision 1
Page 45
© 2018 SAM
5.6 Unit Shutdown
5.6.1 Shutdown
MV-805 unit shutdown is carried out by shutting down the server unit from the unit’s RollCall
“Reset” template, via RollCall Control Panel or via SAM Orbit.
See Section 6.9 “Reset Template” on page 76.
5.6.2 Forced Shutdown
If the MV-805 unit has to be powered down immediately, it is important to carry out the correct
power down procedure for the server platform. Typically, to perform a power down:
1.
Push the power on/off push button for 3-5 seconds to initiate a server shutdown.
Services are shut down as part of a server unit shutdown or restart.
The server shutdown will take a few minutes to complete.
2.
All multiviewer output IP streams will stop.
5.7 Unit Configuration Stages
When the MV-805 unit is installed in its rack, configuration and setting up of the MV-805 is
done in stages:
1.
Configure Unit Settings
via the unit’s RollCall templates.
2.
Configure IP Routing Settings
using the SAM Orbit tool and an Orbit IP routing
project.
3.
Design and Layout Multiviewer Video Wall
using the SAM Orbit tool and an Orbit
multiviewer project.
Important:
Carry out the correct shutdown procedure for the server platform.
Do not pull out the power supply leads from the rear of the unit.
Do not switch off the mains supply to the unit until the shutdown is complete.
Figure 24 Steps for Getting Going
1 Configure Unit Settings
2 Configure IP Routing
Settings
3 Design and Layout
Multiviewer Video Wall
(For RollCall template descriptions,
see Section 6 “RollCall Templates” on page 46.)
See Section 8 “Getting Started 2 - IP Routing (Orbit)” on page 89.
See Section 9 “Getting Started 3 - Design/Layout of Video Wall (Orbit)” on page 108.
See Section 7 “Getting Started 1 - Unit Settings (RollCall Template)” on page 77.
