Snell Advanced Media MV-805, User Manual

Page: 46 / 139

MV-805 IP Multiviewer User Manual RollCall Templates
Issue1 Revision 1 Page 46 © 2018 SAM
6 RollCall Templates
The RollCall MV-805 templates described in this section are:
This section describes the MV-805 IP Multiviewer‘s settings which are in the MV-805 RollCall
templates. The templates are viewable and editable via the SAM Orbit software tool or SAM
RollCall Control Panel, which is part of the SAM RollCall Suite.

(For SAM RollCall Control Panel software installation instructions, see the “RollCall V4 Suite
& RollCall Lite” manual.)
This section describes connecting RollCall Control Panel to a MV-805 and introduces the
MV-805 RollCall template screens and describes each screen.
RollCall templates may be used for:
• Initial configuration.
• Configuration and control of:
- Network interface and comms settings.(May require a MV-805 unit reset.)
- Other unit settings.
- Selection of video wall layouts.
- Configuring TSL support.
- Control of timer widgets on the video wall.
- Shutting down, restarting.
Section Template Page
6.1 Introduction to the RollCall MV-805 Template Screen 47
6.2 System-Setup Template 49
6.3 Layout Template 63
6.4 TSL Template 64
6.5 Timer Control Template 66
6.6 Timer Request Protocol Template 68
6.7 Destination Spigot Template 69
6.8 Source Spigot Template 73
6.9 Reset Template 76