MV-805 IP Multiviewer User Manual
Destination Spigot Template
RollCall Templates 6.7
Issue1 Revision 1
Page 69
© 2018 SAM
6.7 Destination Spigot Template
Video routing to an MV-805 unit is normally done with a SAM video routing IP system, under
the control of a router controller unit (IP-RSC). Routing is then controlled via traditional video
router control methods (i.e. a hard or soft panel) and the user does not have to deal with IP
addresses etc, just user-friendly router port names and numbers.
The RollCall
Destination Spigot
template allows a user to manually specify video IP stream
routing to the MV-805 inputs. MV-805 input spigots are mapped to a range of ‘destination
ports’ of an IP router that the MV-805 is connected to. The template is shown in Figure 44.
Figure 44 RollCall Destination Spigot
Select
Spigot
TAKE
(Button appears after a
change has been made in
the Multicast Flow details.)
New Multicast Flow
details
Information used in an IP flow
in extended RTP headers.
