MV-805 IP Multiviewer User Manual
Making Routes in a SAM IP Routing System
Getting Started 2 - IP Routing (Orbit) 8.7
Issue1 Revision 1
Page 106
© 2018 SAM
8.7 Making Routes in a SAM IP Routing System
In a SAM IP Routing System, video signal routing is carried out in the same way as for
traditional video routers: A router destination port is connected to a source port by making a
route. A route can be made with a hard or soft control panel, or via the RollCall Control Panel
application.
(Router port names and numbers are listed in the
Router Src Ports
and
Router Dst Ports
tabs of SAM Orbit when the IP Routing project is open.)
A SAM IP Routing System contains one or more IP Routing System Controller (IP-RSC) units.
Example, to make a route:
1.
Run RollCall Control Panel on a client PC.
2.
Connect to the “IPRC” function of the IP-RSC unit.
And open the template for its video routing matrix.
3.
View the
XY Panel Control
template. See Figure 86.
4.
Click a Destination, to select it.
5.
Click on a Source.
A route is then made from the source to the destination;
the routing is made in the IP Routing system.
Figure 86 XY Panel Routing Control Template
XYPanel Control Template
IPRC Router Controller device’s
Routing Matrix, Video level
Source
Selection Buttons
Destination
Selection Buttons
