MV-805 IP Multiviewer User Manual
PSU Module Replacement
Maintenance 10.2
Issue1 Revision 1
Page 128
© 2018 SAM
10.2 PSU Module Replacement
One PSU module can be replaced while the MV-805 unit is running.
Overview of PSU module removal:
1.
Push the PSU Release tab, see Figure 113.
2.
Pull out the PSU module using the handle.
3.
Remove the module from the PSU module bay of the MV-805 chassis.
Overview of fitting a new PSU module:
4.
Check that the new PSU module is the same type as the old one.
5.
Push the new module into the PSU module bay of the MV-805 chassis.
6.
Push the module fully in. A click is heard as the module locks into position.
10.3 SSD Replacement
10.4 Cooling Fan Replacement
Note:
Please refer to the third-party-manufacturer server chassis manual for full information on
the removal and re-fitting of a PSU module.
Figure 113 PSU Module Replacement
Note:
Please refer to the third-party-manufacturer information on SSD removal and refitting.
Caution:
If the cooling fans on the MV-805 IP Multiviewer stop for any reason, then the unit should
be switched off immediately. Otherwise, permanent damage may result.
Note:
Please refer to the third-party-manufacturer information on Fan removal and refitting.
