Snell Advanced Media MV-805, User Manual

Page: 89 / 139

MV-805 IP Multiviewer User Manual Getting Started 2 - IP Routing (Orbit)
Issue1 Revision 1 Page 89 © 2018 SAM
8 Getting Started 2 - IP Routing (Orbit)
This section describes part of getting the MV-805 IP Multiviewer going from out-of-the-box.
Section contents:
This section adds an MV-805 into a SAM IP routing system. The SAM Orbit IP routing project
is opened and modified to add in the MV-805.
Assumptions:
• The target network IP routing topology comprises:
• Two media IP networks (Fabrics A and B).
• A single control IP network.
(See Figure 7 on page 20, entitled

“Network Topology - Two Media IP Fabrics (A and B), One Control Network.”

in Section 3.5 Network Topologies.)
• The MV-805 is being set up as part of a SAM IP Routing system which has an existing
SAM Orbit IP Routing project.
• IP information about the target IP routing system is known.
• Connections to the control IP network and to both media IP Fabrics are made.
Items required:
• Client PC running SAM Orbit with an IP routing license and connected to IP networks.
• SAM IQMIX card and a picture display monitor connected to the IP routing system.
Sub-section Page
8.1 Configuring Orbit for Discovering Out-of-Band Devices 90
8.2 Set the MV-805 ‘Device Name’ 92
8.3 Find which Video Router Source and Destination Ports to Use 95
8.4 Assign Router Ports to the MV-805 98
8.5 Set Up Multiviewer Display Outputs (Source Flows) 101
8.6 Multiviewer Display Output 104
8.7 Making Routes in a SAM IP Routing System 106
Configure Unit Settings
Configure IP Routing Settings
Design and Layout
Multiviewer Video Wall
This section.
See Section 9 “Getting Started 3 - Design/Layout of
Video Wall (Orbit)” on page 108.
See Section 7 “Getting Started 1 - Unit Settings
(RollCall Template)” on page 77.
(For RollCall template descriptions,
see Section 6 “RollCall Templates” on page 46.)