MV-805 IP Multiviewer User Manual
Set Up Multiviewer Display Outputs (Source Flows)
Getting Started 2 - IP Routing (Orbit) 8.5
Issue1 Revision 1
Page 101
© 2018 SAM
8.5 Set Up Multiviewer Display Outputs (Source Flows)
For a new MV-805, its multiviewer display outputs are disabled and not yet set up with any
video IP multicast flows. To set up and enable these outputs:
1.
View the
Src Flows Tab
.
2.
Expand the new MV-805 item to see source flows for each spigot (see Figure 80).
3.
Right-click in the device name cell
and select
Enable Flows
in the pop-up menu. See Figure 81.
The
Enable Flows
dialog is shown, see Figure 82.
Figure 80 SAM Orbit - Src Flows Tab (MV-805-16 shown)
New MV-805 item expanded and flows from MV-805 source spigots listed
Src Flows Tab
selected
IP Address of the MV-805 network interface used
Fabric A
Fabric B
Figure 81 Select ‘Enable Flows’
Right-Click in the device name cell
Select
Enable Flows