503
Commands Explanation
OSPFv3 Protocol Configuration Mode
timers spf <spf-delay> <spf-holdtime>
no timers spf
Configure OSPFv3 SPF timer. The
no
timers spf
command recovers default
value.
area <id> stub [no-summary]
no area <id> stub [no-summary]
area <id> default-cost <cost>
no area <id> default-cost
area <id> virtual-link A.B.C.D
[instance-id <instance-id> INTERVAL]
no area <id> virtual-link A.B.C.D
[|INTERVAL]
Configure parameters in OSPFv3
area (STUB area, Virtual link). The no
command restores default value.
4
）
Configure the priority of the interface when electing designated layer3 switch (DR).
Commands Explanation
Interface Configuration Mode
IPv6 ospf priority <priority> [instance-id
<id>]
no IPv6 ospf priority [instance-id <id>]
Sets the priority of the interface in
“designated layer3 switch” election;
the “
no IPv6 ospf priority
[instance-id
<id>]
” command
restores the default setting.
3. Disable
OSPFv3 Protocol
Commands Explanation
Global mode
no router IPv6 ospf [<tag>]
Disable OSPFv3 Routing Protocol
14.7.3 Command For OSPFV3
14.7.3.1 area default cost
Command: area <id> default-cost <cost>
no area <id> default-cost
Function:
Configure the cost of sending to the default summary route in stub or NSSA
area; the “
no area <id> default-cost
” command restores the default value.
Parameter: <id>
is the area number which could be shown as digits 0
～
4294967295, or
