65
z
Information from the debugging of CLI command is classified debugging
Log information can be automatically sent to corresponding channels with regard to
respective severity levels. Amongst the debugging information can only be sent to the
monitor. Those with the Informational level can only be sent to current monitor terminal,
such as the information from the Telnet terminal configuration command can only be
transmitted to the Telnet terminal. Warnings information can be sent to all terminal with
also saved in the SDRAM log buffer zone. And the critical information can be save both in
SDRAM and the NVRAM (if exists) besides sent to all terminals. To check the log save in
SDRAM and the NVRAM, we can use the show logging buffered command. To clear the
log save in NVRAM and SDRAM log buffer zone, we can use the clear logging command
2.2.9.2 System Log Configuration
2.2.9.2.1 System Log Configuration Task Sequence
1. Display and clear log buffer zone
2. Configure the log host output channel
1. Display and clear log buffer zone
Command Description
Admin Mode
show logging buffered [slot <slot-ID> |
level { critical | warnings} | range
<begin-index> <end-index>]
Show detailed log information in
the log buffer channel
clear logging { sdram | nvram }
Clear log buffer zone information
2. Configure the log host output channel
Command Description
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number> ] [level <severity>]
no logging {<ipv4-addr> |
<ipv6-addr>}[ facility <local-number>]
Enable the output channel of the
log host. The “no” form of this
command will disable the output
at the output channel of the log
host.
2.2.9.2.2 System Log Configuration Command
2.2.9.2.2.1 show logging buffered
Command: show logging buffered [slot <slot-ID> | level { critical | warnings} |