510
link state announcements till confirm from the object side is received. If the confirm
packet is not received within the interval, the LSA will be retransmitted. The retransmit
interval must be larger than the time it takes to make a round between two layer 3
switches. The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example:
Configure the LSA retransmit interval of interface vlan 1 to 10 seconds
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf retransmit-interval 10
14.7.3.13 ipv6 ospf transmit-delay
Command: ipv6 ospf transmit-delay <time> [instance-id <id>]
no ipv6 ospf transmit-delay [instance-id <id>]
Function:
Configure the LSA sending delay time on the interface. The “
no ipv6 ospf
transmit-delay [instance-id <id>]
” command restores to the default
Parameter: <id>
is the instance ID ranging between 0~255 and defaulted at 0
<time>
is the delay time of sending LSA on the interface, which is shown in seconds and
ranged between 1
~
65535.
Default:
The default delay time of send LSA on the interface is 1 second by default.
Command Mode:
Interface Mode
Usage Guide:
The LSA ages by time in the layer 3 switches but not in the transmission
process. So by increasing the
transmit-delay
before sending LSA so that it will be sent
out. The command can configure on IPv6 tunnel interface, but it is successful
configuration to only configure tunnel carefully.
Example:
Set the interface vlan 1 LSA sending delay to 3 seconds
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf transmit-delay 3
14.7.3.14 ipv6 router ospf
Command: [no] ipv6 router ospf {area <area-id> [instance-id <instance-id>|tag
<tag> [instance-id <instance-id>]]| tag <tag> area <area-id> [instance-id
<instance-id>]}
Function:
Enable ospf route on the interface; the “
[no] ipv6 router ospf {area
<area-id> [instance-id <instance-id>|tag <tag> [instance-id <instance-id>]]| tag
<tag> area <area-id> [instance-id <instance-id>]}
” command cancels this configuration
Parameter: <area-id>
is an area ID which could be shown in digits ranging between 0
~
4294967295, or an IPv4 address