HPM6 Power Management Controller User Manual
Page 18 of
146
6.3
PARAMETERS SETTING
Press
key for more than 3s to enter into user menu.
★
Parameter setting
After entering the correct password, you can enter parameter settings interface.
Password can be divided into 3 levels: one highest level (engineer, default is 00318) and two
user-defined levels (technician, default is 00317; operator, default is 00316). After entering highest level
password, all configuration items can be set; after entering user-defined level password, users can only
configure parameters within the permission field.
Parameter setting includes the following contents:
★
Module setting
★
Bus setting
★
Generator setting
★
Generator load setting
★
Timers setting
★
Analog inputs setting
★
Digital inputs setting
★
Digital outputs setting
★
Analog outputs setting
★
Breaker setting
★
Synchronization setting
★
Synchronous calibration
★
SLD setting (only configure via upper computer)
★
Engine setting
★
1#
DIN16 setting
★
2# DIN16 setting
★
1# DOUT16 setting
★
2# DOUT16 setting
Example:
Return
>Start delay
>Stop delay
>Start output time
>Stop output time
>Wait for start time
>Wait for stop time
>Load stable time
>Transient fault delay
>Alarm start delay
>Trigger start delay
>Alarm stop delay
Interface 1:
Use
to change setting contents,
to enter settings (interface 2),
to exit
settings menu.
Module setting
Bus setting
Generator setting
Generator load setting
Timers setting >
Analog inputs setting
Digital inputs setting
Digital outputs setting
Analog outputs setting
Breaker setting
