SII IP-5520, User Manual

Page: 222 / 252

5-24
Cut the media
This section describes the cutting procedure using the optional cutter unit (64)
(cutter unit (54) for the IP-5520)
- Move the blower unit (option) in advance to a place where it will not disturb the opera-
tion.
1
Clip both ends of the media with the media
clip.
2
Move the media cutter blade and cut the
media.
- The arrow mark (g) is engraved on the media
cutter blade.
The media cutter blade can only cut in the di-
rection of the arrow mark (g). If the arrow mark
(g) is not oriented in the cutting direction,
change the orientation with the procedure
below.
1
Hold the side of the media cutter blade
and pull it out while releasing the hooks.
2
Invert the media cutter blade so that the
left side comes to the right side and then
install it.
Note
- If the media cutter gets stuck while cutting, return the cutter blade to the
side, remove curls and other causes of the problem, and cut the media by
slowly moving the media cutter blade. Do not forcibly cut a media. Doing so
may damage the blade and cutting performance may be degraded.
- If you drop the media cutter blade, the blade may be damaged, resulting in
poor cutting performance. Handle it with care.
- The media cutter blade may not be able to cut thicker media. In this case, use
a pair of scissors. Forcibly cutting thicker media may damage the media cut-
ter blade and degrade cutting performance.
Arrow