SII IP-5520, User Manual

Page: 227 / 252

6-3
Tro
ub
le
sh
oo
tin
g
6
Cannot print
Symptom/Possible Problem Resolution
USB2.0 cable not connected properly Connect the USB2.0 cable properly.
( P.2-2 [Connection to a computer])
Error LED ON and the message displayed on the LCD Perform the actions specified by the error message.
( P.6-7 [When an error message is displayed])
Error lamp OFF Print the test image.
( P.3-53 [(1) Nozzle print)])
([Test
Pattern] of software RIP)
Clean the print head Run the print head cleaning.
( P.4-19 [Print head cleaning])
Although the printer is in the print mode, printing does not start
and "PH WARMING UP" remains displayed on the operation panel.
Symptom/Possible Problem Resolution
Room temperature Raise the room temperature. (Recommended temperature: 20
to 25ºC)
- Head warming-up is conducted when the room temperature (temperature inside the
printer) is low. Recommended room temperature is 20 to 25˚C.
- When the low room temperature is raised to 20 to 25˚C, it takes time before the tem-
perature of the printer increases. Idle the printer for more than 1 hour before restarting
printing.
- Avoid sharp temperature increase to prevent condensation.
Although the printer is in the print mode, printing does not start
and "PREHEATING" remains displayed on the operation panel.
Symptom/Possible Problem Resolution
Room temperature Raise the room temperature. (Recommended temperature: 20
to 25ºC)
Air flow effect Do not let air from an air conditioner or fan blowing against
the paper guide. Try changing the air flow direction,
orientation of the printer or the location of the printer.