SII IP-5520, User Manual

Page: 206 / 252

5-8
Using a 2 inch core
With this unit, by removing the 3inch adapter, a 2inch paper tube can be used.
To remove the3 inch adapter, the supplied attachment is needed. The removal
procedure of the3inch adapter is explained below.
1
Insert the attachment in the hole in the
center of 3 inch adapter.
2
Turn counterclockwise ( in the arrow direction) the 3 inch adapter and
pull it out together with the attachment.
- Install the removed attachment into the
left and right plates to keep them for later
use.(See the figure at the right hand side.)
- Insert the 3 inch adapter in the slits (holes)
of the left and right plates and turn clock-
wise ( in the arrow direction).
- When installing the 3 inch adapter to the
flange again, push the hook (projection)
of the 3 inch adapter in the slits (holes) of
the flange. Turn the adapter clockwise ( in
the arrow direction).The attachment is not
necessary to install the 3 inch adapter.
Attachment
3 inch adapter
<In case of installing to the plate (right)>
3 inch adapter
Attachment
Slit (hole)
Hook
Attachment
3 inch adapter